Switched-mode power supply 24V 1.05A 25.2W IP67, dimmable
-
Switched-mode power supply 24V 1.05A 25.2W IP67, dimmable
-
- General
- ModelLPF-25D-24
- Output Voltage24V DC
- Rated Current1.05A
- Rated Power25.2W
- Output TypeConstant Current Mode
- Dimming Function3-in-1 (0–10VDC, 10V PWM, Resistance)
- Voltage Range90 – 305 VAC / 127 – 431 VDC
- Frequency Range47 – 63 Hz
- Efficiency (Typ.)85.5%
- Power Factor (PF)PF ≥ 0.97 @ 115 VAC, PF ≥ 0.95 @ 230 VAC, PF ≥ 0.92 @ 277 VAC (full load)
- THD (Total Harmonic Distortion)<20% @ ≥60% load (115/230V), ≥75% (277V)
- AC Current0.4A @ 115 VAC, 0.25A @ 230 VAC, 0.2A @ 277 VAC
- Inrush CurrentCold start 50A @ 230 VAC (twidth = 200μs)
- No. of Drivers on 16A Circuit12 (type B breaker) / 21 (type C breaker) @ 230VAC
- Leakage Current<0.75 mA @ 240 VAC
- Short Circuit ProtectionHiccup mode, auto recovery
- Over Voltage Protection28–35V, auto recovery
- Over Temperature ProtectionShutdown, auto recovery after cooling
- Current Tolerance±5%
- Current Ripple≤5% @ rated current
- Setup/Rise Time500ms, 80ms @ 230VAC; 1500ms, 80ms @ 115VAC
- Hold-up Time16ms @ 230VAC / 115VAC
- Operating Temperature (Tcase)–35°C to +70°C
- Maximum Case Temperature+70°C
- Operating Humidity20 – 95% RH (non-condensing)
- Storage Temperature / Humidity–40°C to +80°C / 10 – 95% RH
- Isolation VoltageI/P–O/P: 3.75kVAC
- Insulation Resistance≥100 MΩ @ 500VDC, 25°C, 70% RH
- EMC ComplianceEN55015, EN61000-3-2 Class C, EN61000-3-3, EN61547, EN61000-4-2~6,8,11, EAC TP TC 020
- Safety StandardsUL8750, CSA C22.2 No. 250.0-08, ENEC EN61347-1/-2-13, EN62384, IP67 (independent), GB19510.1/.14, EAC TP TC 004
- EnclosurePlastic housing, Class II design, IP67 waterproof
- CoolingMethod Free air convection (fanless)
- Lifetime>50,000 hours (Tcase ≤ 70°C)
- Dimensions148 × 40 × 32 mm (L × W × H)
- Weight0.36 kg; Packing: 40 pcs / 15.4 kg / 1.02 CUFT
- WiringAC: Blue (N), Brown (L); Output: Red (+V), Black (–V); Dimming: Purple (DIM+), Pink (DIM–)
- FeaturesBuilt-in active PFC, Class 2 power unit, SELV output, suitable for dry/damp/wet locations, 100μA source current on DIM+
- ApplicationsLED panel lighting, LED downlights, decorative & tunnel lighting, moving signs
- Warranty5 years
