Products catalog

Home/Video, audio, intrusion and access control systems/Intrusion systems/Wired/Control Panels
  •   Control panel and keypad set SECOLINK PAS808+KM20B

    Control panel and keypad set SECOLINK PAS808+KM20B

    Inquire about this item
    Price 87.51 €
    Want another price? Suggest yours!
    In stock.
    In stock: 5 pcs
    Manufacturer
    Secolink

  • Control panel
    On-board wired zones8
    2-wire smoke detector input-
    On-board wireless zones-
    Maximum zones in system8
    On-board PGM3
    Maximum PGM in system8
    User + installer codes5+1
    Duress codeX1, X2, X3, X4 (when X4 = X4 + 1)
    Defaulting user codeYes
    Key switch zone-
    Partitions4
    "Shared" partition (common area)-
    System timers-
    Maximum keypads/modules in system7
    Event log buffer512
    PSTN communicatorIn-built
    In-built interface for backup communicatorTTL Serial
    Data bus protocolKRBUS
    Total phone numbers: CMS reporting + personal dialing4
    Maximum phone numbers for personal dialingUp to 4
    Maximum phone numbers for CMS reportingUp to 4
    Reporting protocolContact ID
    Voice guide for system control over PSTN-
    Voice guide for system programming over PSTN-
    "Roller" detector type-
    "Vibration" detector typeYes
    "Vibration" zone speed (sensitivity)0.01 - 0.25 sec.
    Normal zone speed (sensitivity)0.1 - 2.5 sec.
    Zone loop (detector) typeNC, NO, NC/EOL, NO/EOL, NC/DEOL, NO/DEOL, Vibration
    Arming modeAway, Max Away, Night, Stay.
    Zone definitionEntry/exit, entry/exit forced, interior, interior night armed, follower, interior night follower, perimeter, instant, PGM control;
    24h: burglary, panic silent, panic audible, tamper, fire, smoke, fire button, medical button, fire supervisory, low water level, RF Jam, gas detected, water leakage, high temperature, low temperature
    Zone attributesEnable bypass, no alarm, arm when door is closed, entry route, exit route, fire verification, limitation of alarms, limitation of reporting, pre-alarm
    PGM definitionFire alarm, fire/burglary alarm, burglary alarm, tamper alarm, technical alarm, selected alarms, chime, zone violation, bypass status, selected trouble, exit/entry warning, exit/arm status, full arm status, power supply, resettable power supply, fire power supply, timer, mono/bi switch
    PGM attributesInversion, pulsation, latch, pre-alarm, arm notification, arming failure notification, disarm notification, clear alarm notification
    Rated voltage of power supply (AC)~20 V
    Minimum AC voltage
    (note: ~16 V input voltage lets control panel to generate max 0.7 A output current)    		~16 V
    Maximum AC voltage
    (Note: higher than ~22 V voltage can damage control panel)    		~22 V
    Maximum long term output current of control panel (I+AUX + I+BELL + I+PGM + battery charge):≤1.2 A
    Maximum current of slow blowing fuse used in primary AC250 mA
    Maximum AC power consumption150 mA
    Minimum voltage on +AUX, +BELL, +PGM outputs12 V
    Maximum voltage on +AUX, +BELL, +PGM outputs13.9 V
    Maximum current out of +AUX+0.8 A
    Maximum current out of +BELL+0.8 A
    Maximum current into -PGM-0.05 A
    Maximum current out of +PGM+0.8 A
    Short circuit, overload protection of +BELL, +PGM, +AUXElectronic
    Battery charge, +BELL, +AUX current measurement-
    Failed (waste) backup battery disconnection-
    Maximum battery charging current+0.4 A
    Maximum current of fast blowing fuse used in battery circuit3.15 A
    Control panel disconnect battery when it’s voltage less than9.5 V
    Recommended backup battery12 V, 7 Ah / 20 Hr
    Operational compliance+EN50131, Grade2
    Overall dimensions W x H in mm145 x 77
    Environmental complianceROHS
    Operating temperature-10oC up to +50oC
    Production statusIn production
    Latest firmware versionv0.03
    In-field firmware upgrade (by USB)-
    Keypad
    On-Board zones2
    On-Board PGM-
    Ambient temperature measurement-
    LCD type2 rows 16 symbols each
    Keys in keypad20
    Programmable fast keys (F-Keys)32
    Data bus protocolKRBUS
    Zone loop (detector) typeNC, NO, NC/EOL, NO/EOL, NC/DEOL, NO/DEOL
    Maximum wiring distance to CP300 m
    Power supply9 - 14 V
    Voltage measurement on keypadYes
    Current consumptionBacklight on 100 mA, Baclight off < 50 mA.
    On-Board sounderBuzzer
    Backlight color Display = blue, keypad = yellow
    Character setLatin, Russian, Greek, East European, West European, Azeri, Turkish, Scandinavian.
    User interface typeAdvanced, Simple, Baltic, Asian.
    Overall dimensions W x H in mm115 x 95
    Environmental complianceROHS
    Operating temperature0oC up to +50oC
    Interface for keypad settings programmingUSB
    Interface for keypad firmware updatingUSB